How to Sublimate on Mouse Pads with Cricut for Beginners?

Sublimation can be done more easily with printing on t-shirts mugs or many other purposes. However, the process of sublimation is so attractive as compared to other printing setups. In this article, I will explain how to sublimate mouse pads or phone case and their importance. So just read till the end.

11 Steps – How to Sublimate on Mouse Pads:

Custom mouse pads can be created using sublimation. A few supplies are needed for this relatively easy process.

  1. Make sure you have the right materials. Mouse pad blanks sublimation ink sublimation paper and a heat press are all required for sublimation printing.
  2. Design the image you want to sublimate. Software of your choice can be used for design. Mirror the image before printing.
  3. Measure the mouse pad size and cut out the sublimation paper.
  4. Sublimation paper’s protective film should be pulled off.
  5. On the blank mouse pad place the sublimation paper with the printed image face down.
  6. The sublimation paper should be taped in place.
  7. The temperature should be 350-400 degrees Fahrenheit for the heat press.
  8. The mouse pad blank should be placed in the heat press and the lid should be closed.
  9. 60-90 seconds should be spent pressing the mouse pad.
  10. Once the mouse pad has cooled completely remove it from the heat press.
  11. Unfold your custom mouse pad from the sublimation paper.

How do you Sublimate a picture on a Mouse Pad?

Medium is the pressure setting. Mirror the image and print it on Texprint Paper or even polyester-coated paper-made designs. 

The paper should be placed face down on the mouse pad, settings pad, time and temp, blanks, pad size, and sublimation pad size (Use heat transfer tape if necessary to keep the design in place). With medium pressure, press at 400 degrees F for 30-45 seconds.

1. Can I sun-dry Dry Mousepad?

Make sure the mouse pad is completely dry before using it again to know How to sublimate on mouse pads. 

Moreover, Do not place it in direct sunlight or use a heat source to dry it, as this can harm it. Place your electronics back on top of the mouse pad or mat once it has been thoroughly dry.

2. Can I put my Mouse Pad in the Water?

If the mousepad is wired or RGB, you should not submerge it in a bathtub or large basin (like your kitchen sink). The mousepad should be sprayed with mild dish soap. Never underestimate the power of a little.

3. Should I Microwave my Mousepad?

A mouse pad’s rubber has a low melting point, so heat is also a threat. Therefore, you should avoid putting it in the microwave, using a hairdryer, or soaking it in hot water.

Tips to Enhance your Sublimation on Mouse Pads Efficiency:

  • The temperature of your heat press should be set correctly. A temperature that is too high can cause the ink to bleed and a temperature that is too low can prevent the ink from sublimating properly.
  • Make sure the sublimation paper you use is of high quality to lose the gradian effect of the prints. You will be able to create a vibrant and clear image this way.
  • The mouse pad should be pressed for the recommended amount of time. Y doing this you will ensure the ink gets fully sublimated.
  • Remove the sublimation paper when it is completely cool. You will be able to keep the ink from smearing.

Final Verdict:

To know How to sublimate on mouse pads the Custom mouse pads can be created using sublimation, a permanent process. Compared to other options, it is relatively affordable, and the results are durable and long-lasting. 

Custom mouse pads can be created through sublimation if you are looking for a unique and personalized method. Therefore, it is better to follow the given amazing and experienced steps and get the perfect results of sublimation designs on different mouse pad surfaces.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *